Exhaust parts, Page 24

Steel 10 mm flanges for Garrett and Holset turbocharger inlet, outlet and oil fittings.

A small y-joint to use in headers or manifold joints for example.

Exhaust sleeves to use in joining different pipe diameters in palces where an actual cone reducer wont fit.

Exhaust reducers in stainless or mild steel.Models with three diameters can be cut to fit a pipe with the middle diameter as well.An exhaust pipe reducer allows a diameter change with minimal flow restrictions.

Fits inside a 2.5" exhaust tubing. When installed at the end of an exhaust system, helps lower especially low frequency noise.Total length 285mm.

Vacuum exhaust valves allow mild sounds while streeting, and roaring exhaust sounds on the track.A valve can open and close the exhaust flow. Examples of use are a screamer pipe directly after the downpipe, or a muffler bypass.

High quality DIY straight and angle parts for exhaust. Many parts are also available in stainless steel.

High quality italian handcrafted quality from Supersprint.

Thicker threads and body assure these exhaust U-clamps wont shear threads or bend like the usual single-use clamps.

High quality Simons RST exhaust clamps also for heavy use.

Weldable exhaust flanges in most common sizes like 2.5 and 3". Thickness is 10mm and flanges are made of mild-steel.

RM Motors ZRM90 exhaust flexible connector

RM Motors Universal E002 elliptical silencer

RM Motors Universal E002 elliptical silencer

RM Motors Universal E002 elliptical silencer

RM Motors Universal E002 elliptical silencer

RM Motors Universal E002 elliptical silencer

RM Motors Universal E002 elliptical silencer

RM Motors Universal E002 elliptical silencer

RM Motors Universal E002 elliptical silencer

RM Motors Universal E002 elliptical silencer

RM Motors Universal E002 elliptical silencer

RM Motors Universal E002 elliptical silencer

RM Motors Universal E002 elliptical silencer